Filter
Top Products
3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
3.2 Executing the Diagnostic Test
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the floppy disk drive and turn on the computer while
pressing U.
(The Diagnostics Disk contains the MS-DOS boot files.)
NOTE: To execute the CD-ROM or DVD-ROM test, make sure the CD-ROM
and CD-ROM drive or DVD-ROM and DVD-ROM drive is installed in the
computer.
The following menu will appear:
NOTE: To exit the DIAGNOSTIC TEST MENU, press Esc. If a test program is in
progress, press Ctrl + Break to exit the test program, or press Ctrl + C to stop the test
program.
TECRA M1 Maintenance Manual (960-436) 3-3