Filter
Top Products
4 Replacement Procedures 4.15 Display Assembly
Installing the Display Assembly
To install the display assembly, follow the steps below and refer to figures
4-26 and 4-28.
1. Install the display assembly on the base assembly.
NOTE: When installing the display assembly, be careful not to pinch or damage
any cables.
2. Press along the edges of the display assembly to secure the latches.
3. Connect the internal microphone cable to PJ3001 on the sound board and stick the
glass tape on it.
4. Turn up the insulator and connect the LCD cable to PJ5500 on the system board.
5. Turn up the insulator and connect the two speaker cables to PJ2026 (R, red) and
PJ2027 (L, blue) on the system board.
6. Secure the display assembly with the following screws.
• M2.5×6 FLAT HEAD screw ×2
• M2.5×4 FLAT HEAD screw ×1
7. Turn the computer face down and secure the display assembly with the following
nine screws:
• M2.5×4 FLAT HEAD screw ×3
• M2.5×16 FLAT HEAD screw ×6
4-52 TECRA M1 Maintenance Manual (960-436)