Filter
Top Products
4.23 LCD Module 4 Replacement Procedures
Installing the LCD Module
To install the LCD module, follow the steps below and refer to figures 4-39 and 4-40.
1. Secure the two metal braces to the LCD module with the following screws.
• M2×3 SUPER FLAT screw ×4
2. Lean the LCD module against the lower side of the display cover.
3. Connect the LCD cable to the connector on the back of the LCD module. Stick the
glass tape on the LCD cable.
4. (For SXGA+ models only)
Stick the copper tape on the LCD cable and glass tape. Make sure the copper tape
covers the connector on the display cover and the LCD cable.
5. Seat the LCD module and secure it with the following screws.
• M2×3 SUPER FLAT screw ×4
6. Stick the four mask seals on the sides of the LCD module.
TECRA M1 Maintenance Manual (960-436) 4-73