Filter
Top Products
3 Tests and Diagnostics 3.29 SETUP
* only for Modem Model **only for LAN Model
Alarm Time is set in the sequence of hours and minutes. Seconds cannot be
changed. Alarm Date Option is set in the sequence of month and day. If
Alarm Date is set to Disabled, the computer will be powered on at the same
time every day. Press ↓ to move the cursor to the right and ↑ to move the
cursor to the left when you set the date and time.
NOTE: 1) Do not remove the AC adaptor and battery pack at the same time
when you use this feature. If you do so, data saved by the resume function
will be lost. You must also reset this option.
2) If you have set a password and the computer boots by the Auto Power
On function and Resume is on, the computer will start with the instant
security function enabled. The password = message is not displayed;
however, you must enter the password to use the computer.
(f) Panel Power On/Off
This option sets the Panel Power On/Off function. It is effective only when
Power-up Mode is set to Resume.
Enabled Enables the Panel Power On/Off.
Disabled Disables the Panel Power On/Off (Default)
8. Configuration
This option displays the configuration method.
The devices are initialized when the PNP OS loads.
Setup by OS First, devices necessary for loading the OS will be
initialized. After the PNP OS loads, other devices will
be initialized by the OS. In this case, setup of PC Cards
will be fixed to “Auto-Selected,” and cannot be
changed. (Default)
All Devices All devices will be initialized.
If you are using an OS that does not have PNP capacity, select “All Devices.”
The Display shows the following message:
Device Config. = All Devices
3-88 TECRA M1 Maintenance Manual (960-436)