Filter
Top Products
4.25 Fluorescent Lamp 4 Replacement Procedures
3. Removing bezel
1) Turn the LCD module face up with the insulation sheets on it.
2) Release the latches of the bezel and frame. (five points on upper side, two
points lower side)
3) Remove the double-sided adhesive tape on the bottom of the side of bezel, and
remove the bezel.
NOTE: 1) Be careful not to damage the TAB when releasing the upper latches.
2) When removing the bezel, be sure to remove the double-sided
adhesive tapes on the lower side of bezel slowly so as not to break
the cell. Be careful not to deform the bezel.
Figure 4-53 Replacing TOSHIBA fluorescent lamp (XGA) (3)
TECRA M1 Maintenance Manual (960-436) 4-89