Filter
Top Products
4.25 Fluorescent Lamp 4 Replacement Procedures
8. Tighten the four screws (E) on the sides. Make sure the two latches are precisely
mated.
Figure 4-69 Replacing Sharp fluorescent lamp (SXGA+) (8)
9. Install the protection cover S (A), protection cover G (B), aluminum tape (C) and
fixing tape for lead wire (D). Use new parts.
• Stick the protection covers in the order of (B), (A) to the standard line for
fitting pin.
• Stick the aluminum tape (C) following the sticking standards.
Long sides: Stick to the mark-off line of the lamp cover on the back of bezel.
Short sides: Stick to the edge of lamp cover.
• Stick the fixing wire for lead wire following the sticking standards.
Long sides: Stick to the outline of the LCD module.
Short sides: Stick so that the wire covers the screws.
TECRA M1 Maintenance Manual (960-436) 4-105