Filter
Top Products
30
7.1.4 Local Console Firmware Upgrade
(
continued
)
7.2.1 Remote OSD List Drop-Down
7. Administration
(
continued
)
Firmware Upgrade Recovery
In the event of a firmware upgrade failure, or an aborted firmware upgrade, perform a firmware upgrade recovery by doing the following:
1. Power OFF the switch. If it is part of a daisy chain, disconnect it from the chain.
2. Connect the firmware upgrade cable to the firmware upgrade port.
3. Slide the Firmware Upgrade Recovery Switch to the Recover position.
4. PowertheswitchbackONandrepeattheupgradeprocedure.
5. After the switch has been successfully upgraded, power it OFF and then slide the Firmware Upgrade Recovery Switch back to the Normal position.
6. Iftheswitchispartofadaisychain,reconnectittothedaisychain.
7. Power the switch back ON.
7.2 Remote OSD
UponloggingintotheKVMoverIP,youareconnectedtothefirst
connected computer on the installation that you have access to, and the
Remote OSD appears with the Main tab displayed. (See diagram).
AdministratorshaveaccesstoallfeaturesintheOSD,whereasUsers
only have access to the Main tab and Configuration tab. The
administrative settings of the Remote OSD are described in the
following section.
JustliketheF2 LIST functioninthelocalconsoleOSD,theremoteOSD
allows you to determine which ports are listed on the Main tab. Simply
clickonthedrop-downmenuatthetopoftheOSDscreenandselectan
option.
Setting Description
ALL Lists all of the ports on the installation that
are accessible to the logged-on user,
whether they are powered-ON or not.
POWERED ON Lists all of the ports on the installation that
are both accessible to the logged-on user
and powered-ON.
QVIEW Lists all of the ports on the installation that
are set as Quick View ports by an
administrator.
QVIEW + POWERED ON Lists all of the ports on the installation that
are both set as Quick View ports by an
administrator and are powered ON.