Filter
Top Products
O-1
802 RF Terminal Setup Menu
To change a setting using the 802 RF Terminal Setup Menu:
• Scan START SETUP to enter setup mode
• Scan the parameter you want to change (i.e. Code 3 of 9)
• Choose the setting you want to change and scan the corresponding letter
or
number from the Barpad Table (0-9, A-F)
• When all changes have been made, scan END SETUP
• * indicates default settings
Start Setup End Setup
*/+/*
*/-/*
Code 3 of 9 UPC/EAN
*/A/* */B/*
0 Enable Code 39
1 Disable Code 39
2 Enable Full ASCII Code 39
3 Disable Full ASCII Code 39
4 Enable Accumulate Mode
5 Disable Accumulate Mode
6 Transmit Start/Stop characters
7 Don’t transmit Start/Stop characters
8 Enable Mod 43 Check Character
9 Disable Mod 43 Check Character
A Transmit Mod 43 Check Character
B Don’t transmit Mod 43 Check Character
C Caps Lock ON
D Caps Lock OFF
0 Enable UPC/EAN
1 Disable UPC/EAN
2 Enable Supplements
3 Disable Supplements
4 Transmit UPC-A NSC
5 Don’t transmit UPC-A NSC
6 Transmit UPC-A Check Digit
7 Don’t transmit UPC-A Check Digit
8 Transmit UPC-E NSC & EAN-8 Flag Ch
9 Don’t transmit UPC-E NSC & EAN-8 Flag Ch
A Transmit UPC-E & EAN-8 Check digit
B Don’t transmit UPC-E & EAN-8 Check digit
C UPC-E Compressed transmission
D UPC-E Expanded transmission
E EAN-8 observes 9 & A above
F EAN-8 is forced to transmit 8 digits always
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
2 of 5 Code 2 of 5 Length
*/C/*
0 Enable I 2 of 5
1 Disable I 2 of 5
2 Enable check digit
3 Disable check digit
4 Transmit check digit
5 Don’t transmit check digit
6 Enable 2 of 5
7 Disable 2 of 5
*
*
*
*
*/5/*
Scan 2 digit length (default is 06)
RSS-14
0 Disable RSS-14 2 14 + Identifiers
1 Standard 14 digits 3 14 + UCC-128 Emulation
*/%/*
Appendix O