Filter
Top Products
1-3
Battery Life Indicator
The R/F Terminal detects low AA batteries and displays the following message:
LOW BATTERIES
Finish, Sign Off
Change Batteries
Hit Any Key_
At this point you have approximately 2 minutes of operational time to finish
your transaction (or note where you are leaving off if in the middle of a
transaction) and sign off. After 2 minutes, the R/F Terminal displays:
CHANGE BATTERIES
UNIT SHUT DOWN_
This message displays for 20 seconds before the R/F Terminal signs off from
the host (if signed on) and then shuts itself down. If you turn it back on
without changing batteries, you may experience constant beeping, intermittent
scanning, and very irritating symptoms that look like equipment failure.
Once you remove the batteries, you have 5 minutes to change them before
you lose the date and time in the Real-Time Clock.
The R/F Terminal also has a battery life indicator. Press the STATUS key
to display the remaining battery life of the AA batteries (as well as the date,
time and other information) as follows:
mm/dd/yy hh:mm
alkBAT-zz%
ServerIP=nnn.nnn.nnn.nnn
DeviceIP=nnn.nnn.nnn.nnn
Ch:=n SSID=xxxxxxxxxxxx
WEP=128 Signal=nn%
alk - when Alkaline batteries are specified in Battery setup
rch- when NiMH or specified in Battery
setup
zz=percent or battery life left in numbers i.e. 99, 50, 23
• Server IP either shows the Server's fixed TCPIP address; or if
Device searches out the Server, shows 0.0.0.0.
• Device IP either shows the Device's fixed TCPIP address or, if it
is determined by a DHCP Server, shows 0.0.0.0.
• Ch:=n shows the channel to start using, (the channel of the most
frequently used Access Point).
• SSID=xxxxxxxxxxxx refers to the first 12 characters of the up to
32 character network name.
• WEP=128 or 64 or NO shows how the Device is configured
with an encryption key.