Filter
Top Products
1-5
Upon power-up, the R/F Terminal displays the following opening screen:
802 TERMINAL 1XWFUnnn
ServerIP=nnn.nnn.nnn.nnn
DeviceIP=nnn.nnn.nnn.nnn
Ch:=n SSID=xxxxxxxxxxxx
WEP=128 Rnn
HIT ANY KEY
(The opening screen can be bypassed upon power up. See Chapter 2)
• The first line on the screen, 802 TERMINAL WFUnnn, gives the
firmware revision number.
• Server IP either shows the Server's fixed TCPIP address; or if
Device searches out the Server, shows 0.0.0.0.
• Device IP either shows the Device's fixed TCPIP address or if it
is determined by a DHCP Server, shows 0.0.0.0.
• Ch:=nn shows the channel to start using, (the channel of the most
frequently used Access Point, 01-11).
• SSID=xxxxxxxxxxxx refers to the first 12 characters of the up
32 ch character network name.
• WEP=128 or 64 or NO shows how the Device is configured
with an encryption key.
• Rnn=the radio firmware version.
To move on to the first menu item, press any key on the R/F Terminal keypad.
The display now reads:
DEVICE SIGN ON ----->1
SETUP MODE----------->2
SITE SURVEY----------->3
• Press the 1 key to initiate to a two-way communication host
computer program through an Access Point.
• Press the 2 key to change the configuration of the Terminal Device.
• Press the 3 key to survey the intended site for adequate coverage.
This screen can be skipped (see Chapter 2; RF System Setup), causing the R/F
Terminal to automatically enter DEVICE SIGN ON at power up.