Filter
Top Products
2-2
Default RF Terminal Configuration
Parameter Default Setting Parameter Default Setting
Device IP
DHCP Server Used Disabled
Server IP
Device Searches Start/Stop not transmitted
Subnet Mask
255.255.255.0
Codabar
CLSI format disabled
Starting Channel
1 Disabled
SSID
None check digit not transmitted
WEP Encryption
None Plessey Code disabled
MSI Code
Label Code4 and 5 disabled
Enabled Enabled
Accumulate Mode ON
Code 128
EAN/UCC 128 disabled
stop/start chs not xmit
Code 11
Disabled
check digit disabled
RSS-14
Disabled
Caps lock OFF Disabled
Code 39
Full ASCII Enabled
Code 93
Full ASCII enabled
Disabled
Beep Tone
medium
I 2 of 5 Code disabled
Date Format
mm-dd-yy
6 digit code length
Baud Rate
19200
2 of 5 Code
check digit disabled
Parity
none
Enabled
Data Bits
8
UPC supps disabled
Stop Bits
1
Batteries
Alkaline default UPC-A NSC & check digit
transmitted
Speaker
Speaker Volume 5
Headphone Volume 5
UPC-A NSC & check digit
transmitted
Laser Options
none
Shut Down Time
5 minutes EAN-13 country code &
check digit transmitted
Voice Messages
303015
Encryption
none EAN-13 country code &
check digit transmitted
Control Keys Only
no
Display of year
2 digit UPC-E 1st char & check
digit not transmitted
Skip opening screens
no
Aiming Dot
No
UPC-E 1st char & check
digit not transmitted
Automatic Check Back
No
EAN-8 1st char & check
digit not transmitted
Display Backlight Duration
5 seconds
UPC/ EAN
EAN-8 1st char & check
digit not transmitted
*All parameters are set back to their defaults when reset using the bar coded Setup Menu, even
parameters that are changed by keypad only. Shaded items are keypad access only.
Using the bar code RF Terminal Setup Menu
To use the bar coded Setup Menu, scan these bar codes in this order:
• Start Setup - you should hear 2 beeps
• Setup Parameter bar code (i.e. “Beep Tone”)-you should hear 2
beeps for each scan
• Number bar code that corresponds to the appropriate setting
(i.e. “3” to change the Beep Tone to “high”) - you should hear 2
beeps for each scan
• End Setup-you should hear 3 beeps after END SETUP.