Filter
Top Products
2-5
RF Terminal Setup Parameters
Default settings are shown in bold type in this manual and are marked by a * on
the bar code Setup Menu.
The RF Terminal will typically require no setup changes except, Device Address (if
more than one terminal) and enabling bar codes to be read other than UPC or Code 39.
Device IP Address
Get Device IP from DCHP Server 0.0.0.0
Use a Fixed Address nnn.nnn.nnn.nnn
• Every terminal needs a unique Device IP Address. You can use a fixed
IP address, or you can use a DHCP Server (default) to obtain an IP
address. Enter in the address in the format of nnn.nnn.nnn.nnn (where
each n is a value of 0-9); or if you wish to use a DHCP Server, enter
0.0.0.0. The terminal's default setting is to use a DHCP Server.
Server IP Address
Search for Server IP Address 0.0.0.0
Use a Fixed Address nnn.nnn.nnn.nnn
• The terminal communicates with a Server by IP address. The Server IP
address can be found by a search initiated by the terminal, or you can
enter in a fixed IP address for the server. The default setting in the
terminal is to search, (a setting of 0.0.0.0). If you want to use a fixed
server IP address, enter the IP address nnn.nnn.nnn.nnn (where each n
is a value of 0-9.
Subnet Mask
Default Subnet Mask 255.255.255.0
User Defined Subnet Mask nnn.nnn.nnn.nnn
• If you wish to change the default Subnet Mask of 255.255.255.0, then
enter a new mask in the format of nnn.nnn.nnn.nnn.
Starting Channel
Default Starting Channel 1
User Defined Starting Channel 1-11
• The terminal device's channel should be set to the channel of the most
frequently used Access Point to minimize the initial SIGN ON. To save
time, the Terminal Device will try other channels in case the Starting
Channel does not immediately find an Access Point.
R
F
Setup
R
F
Setup
R
F
Setup
R
F
Setup