Filter
Top Products
1-4
• Signal=nn% shows the signal strength from the best Access
Point with the same SSID (if already SIGNED ON).
Press the STATUS key again to resume processing
To change the AA batteries:
1. Turn OFF the R/F Terminal.
2. Remove the battery holder door on the back of the R/F Terminal by
pressing down on the grooved portion of the door and pushing outward.
3. Remove the old batteries and insert the new ones, making sure to
orient the batteries with the positive (+) end facing down toward
the bottom of the R/F Terminal.
4. If using rechargeable batteries, make sure that rechargeables are
specified. See the previous page to quickly determine the setting
using the STATUS key.
5. Replace the battery door and turn the reader on using the ON/OFF
switch.
6. Sign ON and resume your application.
Recharging the batteries
1. Be sure you have specified rechargeable batteries in the RF
Terminal's Setup. If you ordered NiMH rechargeable batteries with
a RF Terminal, Worth Data makes the change before shipping. See
Battery in the RF Setup.
2. With the RF Terminal shut off, plug the F15 9V power adapter into
the RF Terminal.
3. The firmware in the terminal then checks the level of charge in the
batteries to see if they need charging, displaying the following message:
Checking Batteries
Please Wait………..
4. If the batteries are already charged, the message will disappear. If
the batteries need charging, the following message is displayed:
Charging Batteries
Please Wait………..
R/F Terminal Menu Functions
There are three modes of operation for the R/F Terminal:
DEVICE SIGN ON Signs R/F Terminal on for two-way
communication with host.
SETUP MODE Accesses Setup parameters for Terminal and Base.
SITE SURVEY Allows you to survey the Access Points strength