Filter
Top Products
2-16
Voice Message Partitions
This parameter partitions the total amount of voice messages into different
message lengths. The default setting is:
303015
xx yy zz
where: xx is number of ½ second messages
yy is the number of 1-second messages
zz is the number of 2-second messages
The total time allotted must not exceed 75 seconds. To change the partitions, scan
or enter 6 digits total; 2 for the number of ½-second messages, 2 for the number
of 1-second messages and 2 for the number of 2-second messages. See the
default setting as an example.
WARNING: changing the Voice Message Partitions parameter after you
have recorded messages could result in having to re-record some of them;
they would still be there but longer messages may get cut up and shorter
ones combined.
Shut Down Time
By default, if the RF Terminal is inactive (no keystrokes or scanning) for
more than 5 minutes, it will shut itself down in order to conserve batteries.
This includes SIGNING OFF if appropriate. To resume operation, you
must turn the RF Terminal back on using the ON/OFF key. To change the
amount of time the RF Terminal waits before shutting down:
• Scan Shut Down Time
• Scan two digits - the default is 05 (5 minutes)- to correspond to the
length of time in minutes. For example, 01 would be 1 minute.
If you want to prevent the RF Terminal from shutting off automatically at
all, set the Shut Down Time to 00.
Laser Scanner Options
None 0
Double Decode 1
4.5 second laser beam 3
Transmit EAN-13 normally C
Transmit EAN-13 in ISBN format D
Transmit UPC-A normally E
Transmit UPC-A in EAN-13 format (with 0 flag character) F
• By default, the RF Terminal has no special laser options set. If any of
the features below seem to fit your situation, set them appropriately.
Settings C through F are not laser-dependent and are for UPC/EAN bar
code types only. See the UPC/EAN parameter for more information
Other
Other
Other