Filter
Top Products
20 Zoom AP+2 User’s Guide
9
99
9 Click the
Logout
icon at the top right of the screen, then close
your Web browser.
10
1010
10 Reset the computer’s TCP/IP settings to what they were
before you changed them.
11
1111
11 Unplug the power cube from the strip or wall outlet and
disconnect the Ethernet cable from the Ethernet port of the
computer.
12
1212
12 Move the AP+2 to a location at the edge of the access
point’s or wireless gateway’s coverage area that you want to
extend.
13
1313
13 Plug the included power cube into a power strip or wall
outlet and then plug its other end into the
Power
jack on the
back of the access point.
Important!
Only use the power cube shipped with the access point. Other
power cubes may damage the device.
The
TX/RX
,
LINK/ACT
, and
Power
lights on the top of
the device should blink while the AP+2 boots up and
configures itself. When a valid connection has been made, the
LINK/ACT
light will become solid.
14
1414
14
You may want to try to position the unit’s antennas to
improve wireless speed and coverage. Typically, the antennas
should not be parallel. For example, try making one vertical
and the other horizontal.
Congratulations!
Your AP+2 is installed as a repeater.