Filter
Top Products
Chapter 1: Installing the AP+2 as an Access Point 7
1
Installing the AP+2 as an
Access Point
This chapter provides detailed instructions about installing the
AP+2 as an access point. If you have already done this using
the printed Quick Start booklet, you do not have to perform the
steps in this chapter. Instead, you should now set up security
for your wireless network. To do this, please continue with
Chapter 4: Setting Security on page 21.
Installing the Hardware
1
11
1 Connect the AP+2 to your router, combination
modem/router, switch, or hub. To do this, plug one end of the
included Ethernet cable into the
RJ-45
port on the back of the
AP+2 and plug the other end into an available Ethernet port
on the router, modem/router, switch, or hub. The AP+2
works with both 100 and 10 Mbps Ethernet port speeds.
2
22
2 Plug the included power cube into a power strip or wall outlet
and then plug its other end into the
Power
jack on the back of
the access point.
Important!
Only use the power cube shipped with the AP+2. Other
power cubes may damage the device.