Filter
Top Products
Prestige 128MH PSTN Router/Hub
6-4
Chapter 6 TCP/IP Configuration for LAN-to-LAN
Table 6-1. Remote Node Network Layer Options for a TCP/IP Configuration
Field Description Option
Route Make sure [IP] is among the protocols in the Route field.
[IP]
([IP/IPX/IP+IPX])
IP Address Enter the IP address of the gateway at the remote site (in this
case, headquarters). If the remote router is using a different IP
address than the one entered here, your Prestige will drop the
call.
Edit IP/IPX/Bridge Press the space bar to change it to [Yes] and press [Enter] to
go to Menu 11.3 - Remote Node Network Layer Options Menu.
[Yes]
([Yes/No])
Rem IP Address This will show the IP address you entered for this Remote Node
in the previous menu.
Rem IP Subnet
Mask
Enter the subnet mask for the remote network.
My WAN Addr Some implementations, especially the UNIX derivatives,
require hosts on both ends of the PSTN/ISDN link to have
separate addresses from the LAN, and that the addresses must
have the same network number. If this is the case, enter the IP
address assigned to the WAN port of your Prestige.
Note that this is the address assigned to your local Prestige,
not the remote router.
(See Figure 6-3 for an explanation of My WAN Addr. With
Sample IP Addresses)
Single User
Account
This field should be set to [Yes] to enable the Single User
Account (Network Address Translation) feature for this site.
Use the space bar to toggle between [Yes] and [No]. See
Chapter 3 - Internet Access Application for more information on
the Single User Account feature.
[Yes/No]
Server IP address If you are using the Single User Account feature and you want
to make a server on your LAN (for example, a Web server)
accessible to outside users, enter that servers IP address here.