Filter
Top Products
Prestige 128MH PSTN Router/Hub
8-4
Chapter 8 Bridge Configuration for LAN-to-LAN
8.3 LAN-to-LAN Application
A typical LAN-to-LAN application is to use your Prestige to call from one office to another office
such that stations on one network have access to stations on the remote side and vice versa. You
will need to configure a Remote Node in order to dial out to another office.
8.3.1 Remote Node Setup
Follow the procedure in Chapter 5 to fill the protocol-independent parameters in Menu 11.1 -
Remote Node Profile. For the protocol-dependent parameters, you will need to configure Menu
11.3 - Remote Node Network Layer Options.
To edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 8-2, follow these
steps:
Step 1. In Menu 11.1, make sure the [Bridge] field is set to [Yes].
Step 2. Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to toggle and
set the value to [Yes], and press [Enter] to edit Menu 11.3 - Network Layer Options.
Figure 8-2. Menu 11.3 - Remote Node Network Layer Options for Bridging Configuration
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Server IP Addr= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
IPX Options:
Dial-On-Query= No
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Bridge Options:
Dial-On-Broadcast= No
Ethernet Addr Timeout(min)= 0
Enter here to CONFIRM or ESC to CANCEL: