Filter
Top Products
Prestige 128MH PSTN Router/Hub
7-10
Chapter 7 Novell IPX Configuration for LAN-to-LAN
Figure 7-6. Menu 12.2 - Edit IPX Static Route
Table 7-3 contains the instructions on how to configure the Edit IP Static Route Menu.
Table 7-3. Edit IPX Static Route Menu Fields
Field Description
Server Name In this field, enter in the name that has been configured for the server. This name must
be the exact name configured in the NetWare server.
Network # This field contains the internal network number of the remote server that you wish to
access. Do not use [00000000] or [FFFFFFFF] for this field.
Node #
This field contains the address of the node on which the server resides. If you are using a
Novell IPX implementation, this value is [000000000001].
Socket # This field contains the socket number on which the server will receive service requests.
The default for this field is hex [0451].
Type # This field identifies the type of service the server provides. The default for this field is hex
[0004].
Gateway Node
In this field, enter the number (1-4) of the Remote Node that is linked to this static route.
That is, the Remote Node that you wish to route the packet to.
Hop Count and
Tick Count
These two fields have the same meaning as those in the Remote Node Setup.
Once you have completed filling in the menu, press [Enter] at the message [Press Enter to Confirm] to
save your selections, or press [Esc] to cancel to cancel your selections.
Menu 12.2 - Edit IPX Static Route
Route #= 11
Server Name= ?
Active= Yes
Network #= ?
Node #= 000000000001
Socket #= 0451
Type #= 0004
Hop Count= 2
Tick Count= 3
Gateway Node= 1
Press ENTER to CONFIRM or ESC to CANCEL: