Filter
Top Products
Prestige 128MH PSTN Router/Hub
7-7
Chapter 7 Novell IPX Configuration for LAN-to-LAN
7.5.1 Remote Node Setup
Follow the procedure in Chapter 5 to define the protocol-independent parameters in Menu 11.1 -
Remote Node Profile. For the protocol-dependent parameters in Menu 11.3 - Remote Node
Network Layer Options, follow the ensuing instructions. If your Prestige is configured to receive
an incoming call, you can also configure the default dial-in parameters in Menu 13.
To edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 7-4, follow these
steps:
Step 3. In Menu 11.1, make sure [IPX] is among the protocols in the Route field. (The Route
field should display Route = IPX or Route = IP + IPX.)
Step 4. Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to toggle and
set the value to [Yes], and press [Enter] to edit Menu 11.3 - Network Layer Options.
Figure 7-4. Menu 11.3 - Remote Node Network Layer Options for Novell IPX Application
The Table 7-2 describes the IPX protocol-dependent parameters of the Remote Node Setup.
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Server IP Addr= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
IPX Options:
Dial-On-Query= No
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CANCEL: