Filter
Top Products
Prestige 128MH PSTN Router/Hub
4-5
Chapter 4 Telecommuting
Table 4-2. Default Dial-in Setup Fields
Field Description Option
Telco Options: CLID Authen This field sets the CLID authentication parameter for all
incoming calls. There are three options for this field:
l None - No CLID is required.
l Required - Must provide CLID, or call is
disconnected.
l Preferred - If the CLID is available then CLID will be
used to do authentication. If the CLID is not
available the call will continue.
[None]
[Required]
[Preferred]
PPP Options: Recv. Authen This field sets the authentication protocol used for
incoming calls. User names and passwords are
configured in the next section (Remote users/Dial-in
Users Setup). Options for this field are:
l CHAP/PAP - Your Prestige will try CHAP first, but
PAP will be used if CHAP is not available.
l CHAP - Use CHAP only.
l PAP - Use PAP only.
l None - Your Prestige tries to acquire CHAP/PAP
first, but no authentication is required if CHAP/PAP
is not available.
[CHAP/PAP]
[CHAP]
[PAP]
[None]
PPP Options: Mutual
Authen
Some vendors (for example, Cisco) implement a type of
mutual authentication. That is, the node that initiates the
call will request a user name and password from the far
end that they are dialing to. If the Remote Node that is
dialing in implements this type of authentication, set this
field to Yes.
[Yes/No]
PAP Login This field will only be enabled if the Mutual Authen. Field
is set to [Yes]. Enter in the login name to be used to
respond to the far end’ s PAP authentication request. This
field does not apply to CHAP authentication.
PAP Password This field will only be enabled if the Mutual Authen. Field
is set to [Yes]. Enter in the PAP password to be used to
respond to the far end’ s authentication request. This field
does not apply to CHAP authentication.