Filter
Top Products
Prestige 128MH PSTN Router/Hub
8-6
Chapter 8 Bridge Configuration for LAN-to-LAN
8.3.2 Default Dial-In Setup for Bridge
There is only one dial-in parameter [PPP Options: Recv. Authen] in Menu 13 - Default Dial-In
Setup that you need to fill out for Bridging applications, as shown in Table 8-4.
Table 8-4. Default Dial-in Setup Field for Bridging Applications
Field Description
(Menu 13)
PPP Options: Recv. Authen Make sure this field is set to [Yes].
Once you have completed filling in this menu, press [Enter] at the message [Press Enter to Confirm] to
save your selections, or press [Esc] to cancel your selection.
8.3.3 Bridge Static Route Setup
You can configure Bridge static routes for your Bridging applications in Menu 12.3, as shown in
Figure 8-3.
Figure 8-3 Menu 12.3 - Edit Bridge Static Route
Menu 12.3 - Edit Bridge Static Route
Route #: 21
Route Name=
Active= No
Ether Address= ?
IP Address=
Gateway Node= 1
Press ENTER to CONFIRM or ESC to CANCEL: