Filter
Top Products
Prestige 128MH PSTN Router/Hub
2-14
Chapter 2 Hardware Installation & Initial Setup
2.8 WAN Setup
This section describes how to configure the WAN ports on your Prestige 128MH by using Menu
2- WAN Setup. The Menu 2 - WAN Setup is used for entering information about your Modem or
ISDN TA connected to the serial port WAN Port 1 and the modem line connected internally to
WAN port 2 or 3 (LINE 1,2). Select a WAN Port (# 1,2, or3) that you wish to configure first.
Then configure the WAN Port from Submenu 2.1. If advanced setup is required, go into Menu 2.2.
When you are finished, press [Enter] in Menu 2.1. Your Prestige will save the information to
ROM first; then use this information to initialize the Wan Port and the attached modem or ISDN
TA.
Note on WAN Setup
Before you connect a leased line modem or ISDN TA to your Prestige, make sure to configure the
device accordingly. To configure the modem or ISDN TA, refer to the instructions provided by the
manufacturer
2.8.1 Prestige 128MH WAN Port Setup
Prestige 128MH supports three WAN port connections with Modems or ISDN TAs.
To configure the WAN ports on Prestige 128MH, follow these steps:
Step 1. Select option [2. WAN Setup] in the Main Menu by typing 2 at the menu selection
number prompt.
Step 2. In Menu 2 - WAN Port Setup, as shown in Figure 2-8, enter the number (1,2, or 3) of
the WAN port you wish to configure.
l Select option [1. Wan Port 1(External)] to setup the WAN port 1 with external
modem or ISDN TA parameters.
l Select options [2,3 Wan Port 2,3(Internal)] to configure the Internal 56K
Modems on WAN Port 2 and 3.