Filter
Top Products
Prestige 202H User’s Guide
6-6 Ethernet Setup
Table 6-2 Menu 3.2 TCP/IP and DHCP Ethernet Setup
FIELD DESCRIPTION EXAMPLE
Primary DNS
Server
Secondary
DNS Server
Enter the IP addresses of the DNS servers. The DNS servers are passed
to the DHCP clients along with the IP address and the subnet mask.
Remote
DHCP Server
If Relay is selected in the DHCP field above, then enter the IP address of
the actual, remote DHCP server here.
Use the instructions in the following table to configure TCP/IP parameters for the LAN port.
Table 6-3 TCP/IP Ethernet Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
TCP/IP Setup
IP Address Enter the IP address of your router in dotted decimal notation.
192.168.1.1
(default)
IP Subnet Mask
Your router will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use
the subnet mask computed by the router.
255.255.255.0
RIP Direction
Press [SPACE BAR] to select the RIP direction from Both/None/In Only/
Out Only.
Both (default)
Version
Press [SPACE BAR] to select the RIP version from RIP-1/RIP-2B/ RIP-
2M.
RIP-1 (default)
Edit IP Alias
The Prestige supports three logical LAN interfaces via its single physical
Ethernet interface with the Prestige itself as the gateway for each LAN
network. Press [SPACE BAR] to select Yes and then press [ENTER] to
display menu 3.2.1
Yes
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
6.4 IP Alias
IP Alias allows you to partition a physical network into different logical networks over the same Ethernet
interface. The router supports three logical LAN interfaces via its single physical Ethernet interface with the
router itself as the gateway for each LAN network.