ZyXEL Communications 202H Network Card User Manual


 
Prestige 202H User’s Guide
8-4 Remote Node Configuration
Table 8-1 Menu 11.1 Remote Node Profile
FIELD DESCRIPTION EXAMPLE
Call Back
This field is applicable only if Call Direction is set to Both. Otherwise, a
N/A appears in the field.
This field determines whether or not your Prestige will call back after
receiving a call from this remote node.
If this option is enabled, your Prestige will disconnect the initial call from
this node and call it back at the Outgoing Primary Phone Number (see
section 10.4 Callback Overview).
Yes
Outgoing:
My Login
This is a required field [?] if Call Direction is either Both or Outgoing.
Enter the login name for your Prestige when it calls this remote node.
My Password
This is a required field [?] if Call Direction is either Both or Outgoing.
Enter the password for your Prestige when it calls this remote node.
Authen This field sets the authentication protocol used for outgoing calls. Options
for this field are:
CHAP/PAP – Your Prestige will accept either CHAP or PAP when
requested by this remote node.
CHAP – accept CHAP only.
PAP – accept PAP only.
CHAP/PAP
Pri(mary)
Sec(ondary)
Phone #
Your Prestige always calls this remote node using the Primary Phone
number first for a dial-up line.
If the Primary Phone number is busy or does not answer, your Prestige
will dial the Secondary Phone number if available.
Some areas require dialing the pound sign # before the phone number for
local calls. A # symbol may be included at the beginning of the phone
numbers as required.
Edit PPP
Options
To edit the PPP options for this remote node, move the cursor to this
field. Press [SPACE BAR] and then [ENTER] to select Yes and press
[ENTER]. This will bring you to Menu 11.2 – Remote Node PPP Options.
For more information on configuring PPP options, see section 8.6.
No
Rem IP Addr
This is a required field [?] if Route is set to IP. Enter the IP address of the
remote gateway.
Edit IP
Press [SPACE BAR] to select Yes and press [ENTER] to go to Menu
11.3 – Remote Node Network Layer Options.
No