Filter
Top Products
ZyWALL 2 and ZyWALL 2WE
12-8 NAT
Figure 12-4 Menu 11.3: Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
Table 12-3 Applying NAT in Menus 4 & 11.3
FIELD DESCRIPTION OPTIONS
When you select this option the SMT will use Address Mapping Set 1
(menu 15.1 - see section 12.3.1 for further discussion). You can
configure any of the mapping types described in Table 12-2. Choose
Full Feature if you have multiple public WAN IP addresses for your
ZyWALL.
Full Feature
NAT is disabled when you select this option.
None
Network
Address
Translation
When you select this option the SMT will use Address Mapping Set
255 (menu 15.1 - see section 12.3.1). Choose SUA Only if you have
just one public WAN IP address for your ZyWALL.
SUA Only
12.3 NAT Setup
Use the address mapping sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. You can see two NAT address mapping sets in menu 15.1. You can
only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the SMT
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= Full Feature
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.