Filter
Top Products
ZyWALL 2 and ZyWALL 2WE
24-4 Remote Management
Table 24-1 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION EXAMPLE
Secured Client
IP
The default 0.0.0.0 allows any client to use this service to remotely
manage the ZyWALL. Enter an IP address to restrict access to a client
with a matching IP address.
0.0.0.0
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
24.7.1 Remote Management Limitations
Remote management over LAN or WAN will not work when:
1. A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
2. You have disabled that service in menu 24.11.
3. The IP address in the Secured Client IP field (menu 24.11) does not match the client IP address.
If it does not match, the ZyWALL will disconnect the session immediately.
4. There is an SMT console session running.
5. There is already another remote management session of the same type (web, FTP or Telnet)
running. You may only have one remote management session of the same type running at one
time.
6. There is a web remote management session running with a Telnet session. A Telnet session will be
disconnected if you begin a web session; it will not begin if there already is a web session.
24.8 Remote Management and SUA/NAT
When SUA/NAT is enabled:
Use the ZyWALL’s WAN IP address when configuring from the WAN.
Use the ZyWALL’s LAN IP address when configuring from the LAN.