Filter
Top Products
ZyWALL 2 and ZyWALL 2WE
VPN/IPSec Setup 27-17
Table 27-8 Advanced IKE VPN Rule Setup
LABEL DESCRIPTION
Local Port End
Enter a port number in this field to define a port range. This port number must be
greater than that specified in the previous field (or equal to it for configuring an individual
port).
Remote Address
Start
Enter the beginning (static) IP address, in a range of computers behind the remote
secure gateway. This address should be specific to the remote computer using the VPN
tunnel. If you wish to configure the tunnel for a single IP address, enter it in this field and
again in the Remote Address End field.
Remote Address
End/Mask
Enter the end (static) IP address, in a range of computers on behind the remote secure
gateway. This address should be specific to the remote computer using the VPN tunnel.
If you wish to configure the tunnel for a single IP address, enter it in both the Remote
Address Start field and here.
Remote Port Start
0 is the default and signifies any port. Type a port number from 0 to 65535. Some of the
most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80, HTTP; 25, SMTP; 110,
POP3
Remote Port End
Enter a port number in this field to define a port range. This port number must be
greater than that specified in the previous field (or equal to it for configuring an individual
port).
My IP Address
Enter the WAN IP address of your ZyWALL. The ZyWALL uses its current WAN IP
address (static or dynamic) in setting up the VPN tunnel if you leave this field as 0.0.0.0.
The VPN tunnel has to be rebuilt if this IP address changes.
Local ID Type
Select IP to identify this ZyWALL by its IP address.
Select DNS to identify this ZyWALL by a domain name.
Select E-mail to identify this ZyWALL by an e-mail address.
Local Content
When you select IP in the Local ID Type field, type the IP address of your computer or
leave the field blank to have the ZyWALL automatically use its own IP address.
When you select DNS in the Local ID Type field, type a domain name (up to 31
characters) by which to identify this ZyWALL.
When you select E-mail in the Local ID Type field, type an e-mail address (up to 31
characters) by which to identify this ZyWALL.
The domain name or e-mail address that you use in the Content field is used for
identification purposes only and does not need to be a real domain name or e-mail
address.