Filter
Top Products
ZyWALL 2 and ZyWALL 2WE
WAN Setup 6-1
Chapter 6
WAN Setup
This chapter describes how to configure the WAN using menu 2.
6.1 Introduction to WAN Setup
This chapter explains how to configure settings for your WAN port.
6.2 Cloning The MAC Address
The MAC address field allows users to configure the WAN port's MAC address by using either the factory
default or cloning the MAC address from a computer on your LAN. Once it is successfully configured, the
address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the
setting in menu 2 or upload a different rom file.
ZyXEL recommends that you clone the MAC address of a computer on your LAN
even if your ISP does not require MAC address authentication.
6.3 WAN Setup
From the main menu, enter 2 to open menu 2.
Figure 6-1 MAC Address Cloning in WAN Setup
The following table contains instructions on how to configure your WAN setup.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A