Filter
Top Products
ZyAIR B-500 Wireless Access Point User’s Guide
9-6 Maintenance
Table 9-4 Channel Usage
LABEL DESCRIPTION
Signal This field displays the strength of the AP’s signal. If you must choose a channel that’s
currently in use, choose one with low signal strength for minimum interference.
Network Mode “Network mode” in this screen refers to your wireless LAN infrastructure (refer to the
Wireless LAN chapter) and WEP setup.
Network modes are: Infra (infrastructure), Infra, WEP (Infrastructure with WEP
encryption is enabled), Ad-Hoc, or Ad-Hoc, WEP.
Refresh
Click Refresh to reload the screen.
9.5 F/W Upload Screen
Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a "*.bin"
extension, e.g., "zyair.bin". The upload process uses HTTP (Hypertext Transfer Protocol) and may take up to
two minutes. After a successful upload, the system will reboot. See the Firmware and Configuration File
Maintenance chapter for upgrading firmware using FTP/TFTP commands.
Click MAINTENANCE and then F/W Upload to display the screen as shown. Follow the instructions in
this screen to upload firmware to your ZyAIR.
Figure 9-5 Firmware Upload
The following table describes the labels in this screen.