Chapter 6 Tutorials
ZyWALL USG 300 User’s Guide
130
Figure 54 Network > Interface > Trunk > Edit > Member
4 Use the default values for the rest of the settings. Click OK to save these changes and
return to the previous screen.
6.1.4 Zones
This example sets up the LAN, WAN, and DMZ zones as shown below.
Ethernet interface ge2 does not have any physical ports associated with it, so it does not matter
to which zone it is assigned or if it is assigned to any zone at all. The only change you must
make is to remove ge4 from the DMZ zone and add it to the WAN zone. The following steps
accomplish this by removing ge4 from the DMZ zone and changing WAN member ge2 into
ge4, leaving ge2 unassigned to any zone.
1 Click Network > Zone. The following screen appears.
Figure 55 Network > Zone, Initial
2 Click the Edit icon for DMZ, as shown above because you have to remove ge4 from the
DMZ before you can add it to the WAN.
Table 32 Zones Example
ETHERNET
INTERFACE
DEFAULT ZONE FINAL ZONE
ge1 LAN LAN
ge2 WAN ---
ge3 WAN WAN
ge4 DMZ WAN
ge5 DMZ DMZ