Filter
Top Products
Chapter 27 Application Patrol
ZyWALL USG 300 User’s Guide
397
27.10.1 Other Configuration Add/Edit
The Other Configuration Add/Edit screen allows you to create a new condition or edit an
existing one. To access this screen, go to the Other Protocol screen (see Section 27.10 on
page 395), and click either the Add icon or an Edit icon.
Figure 309 AppPatrol > Other > Edit
The following table describes the labels in this screen.
Add icon Click the Add icon in the heading row to add a new first entry.
The Active icon displays whether the entry is enabled or not. Click the Active icon
to activate or deactivate the entry. Make sure you click Apply to save and apply the
change.
Click the Edit icon to go to the screen where you can edit the entry.
Click the Add icon in an entry to add a new entry below the current entry.
Click the Remove icon to delete an existing entry from the ZyWALL. A window
displays asking you to confirm that you want to delete the entry.
To move an entry up or down in the list, click on the Move to N icon next to the
entry, and type the line number (# field) of where you want to move the entry. The #
field is updated accordingly. The ordering of the entries is important as they are
applied in order of their numbering.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 116 AppPatrol > Other (continued)
LABEL DESCRIPTION
Table 117 AppPatrol > Other > Edit
LABEL DESCRIPTION
Enable Select this check box to turn on this policy.
Port Use this field to specify a specific port number to which to apply this policy. Type
zero, if this policy applies for every port number.