Filter
Top Products
Chapter 41 ISP Accounts
ZyWALL USG 300 User’s Guide
565
Encryption
Method
This field is available if this ISP account uses the PPTP protocol. Use the drop-
down list box to select the type of Microsoft Point-to-Point Encryption (MPPE).
Options are:
nomppe - This ISP account does not use MPPE.
mppe-40 - This ISP account uses 40-bit MPPE.
mppe-128 - This ISP account uses 128-bit MMPE.
Authentication
Type
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when requested by this
remote node.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above. The password can only
consist of alphanumeric characters (A-Z, a-z, 0-9). This field can be blank.
Retype to
Confirm
Type your password again to make sure that you have entered is correctly.
Server IP If this ISP account uses the PPPoE protocol, this field is not displayed.
If this ISP account uses the PPTP protocol, type the IP address of the PPTP server.
Connection ID This field is available if this ISP account uses the PPTP protocol. Type your
identification name for the PPTP server. This field can be blank.
Service Name If this ISP account uses the PPPoE protocol, type the PPPoE service name to
access. PPPoE uses the specified service name to identify and reach the PPPoE
server. This field can be blank.
If this ISP account uses the PPTP protocol, this field is not displayed.
Compression Select On button to turn on stac compression, and select Off to turn off stac
compression. Stac compression is a data compression technique capable of
compressing data by a factor of about four.
Idle Timeout This value specifies the number of seconds that must elapse without outbound
traffic before the ZyWALL automatically disconnects from the PPPoE/PPTP server.
This value must be an integer between 0 and 360. If this value is zero, this timeout
is disabled.
OK Click OK to save your changes back to the ZyWALL. If there are no errors, the
program returns to the ISP Account screen. If there are errors, a message box
explains the error, and the program stays in the ISP Account Edit screen.
Cancel Click Cancel to return to the ISP Account screen without creating the profile (if it is
new) or saving any changes to the profile (if it already exists).
Table 192 Object > ISP Account > Edit (continued)
LABEL DESCRIPTION