Filter
Top Products
Chapter 46 Logs
ZyWALL USG 300 User’s Guide
626
Figure 468 Maintenance > Log > View Log
If an event generates log messages and alerts, it is displayed in red. Otherwise, it is displayed
in black. The following table describes the labels in this screen.
Table 220 Maintenance > Log > View Log
LABEL DESCRIPTION
Show Filter /
Hide Filter
Click this button to show or hide the filter settings.
If the filter settings are hidden, the Display, Email Log Now, Refresh, and Clear
Log fields are available.
If the filter settings are shown, the Display, Priority, Source Address,
Destination Address, Service, Keyword, and Search fields are available.
No Filter These fields are displayed when you hide the filter.
Display Select the log(s) you want to view. You can also view All Logs on one screen, or
you can view the Debug Log. The screen is updated right after you change the
selection.
Email Log
Now
Click this button to send the selected log message(s) to the Active e-mail
address(es) specified in the Send Log To field on the Log Settings page. (See
Section 46.3 on page 628 or Section 46.3.1 on page 629 for more information
about these fields.)
Refresh Click this button to update the information on the log screen.
Clear Log Click this button to clear the whole log, regardless of what is currently displayed on
the screen.
Filter These fields are displayed when you show the filter. When the filter is shown, the
filter criteria are not applied until you click the Search button.
Display Select the log message(s) you want to view. You can also view All Logs at one
time, or you can view the Debug Log.
Priority This field is read-only if the Category is Debug Log. Select the lowest-priority log
messages you would like to see. The log will display every log message with this
priority or higher. Choices are: emerg, alert, crit, error, warn, notice, and info,
from highest priority to lowest priority.
Source
Address
Type the IP address of the source of the incoming packet when the log message
was generated. Do not include the port in this filter.
Destination
Address
Type the IP address of the destination of the incoming packet when the log
message was generated. Do not include the port in this filter.
Service Select the service whose log messages you would like to see. The web
configurator uses the protocol and destination port number(s) of the service to
select which log messages you see.