Filter
Top Products
Chapter 4 Wizard Setup
ZyWALL USG 300 User’s Guide
97
4.7.1 VPN Express Wizard
Click the Express radio button as shown in Figure 33 on page 96 to display the following
screen.
Figure 34 VPN Express Wizard: Step 2
The following table describes the labels in this screen.
4.8 VPN Express Wizard - Remote Gateway
The Remote Gateway policy identifies the IPSec devices at either end of a VPN tunnel.
Table 15 VPN Express Wizard: Step 2
LABEL DESCRIPTION
Name Type the name used to identify this VPN connection (and VPN gateway). You may
use 1-31 alphanumeric characters, underscores(
_), or dashes (-), but the first
character cannot be a number. This value is case-sensitive.
Secure
Gateway
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) to identify the remote IPSec router by its IP address or a domain name. Set
this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address.
Pre-Shared
Key
Type your pre-shared key in this field. A pre-shared key identifies a communicating
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure
connection.
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with “0x”.
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
used on both ends.
Next Click Next to continue.