Filter
Top Products
Chapter 1 Introducing the ZyWALL
ZyWALL USG 300 User’s Guide
54
The following table describes the LEDs.
1.3 Management Overview
You can use the following ways to manage the ZyWALL.
1.3.1 Web Configurator
The web configurator allows easy ZyWALL setup and management using an Internet browser.
This User’s Guide provides information about the web configurator.
Figure 2 Managing the ZyWALL: Web Configurator
Table 1 Front Panel LEDs
LED COLOR STATUS DESCRIPTION
PWR Off The ZyWALL is turned off.
Green On The ZyWALL is turned on.
Red On There is a hardware component failure. Shut down the
device, wait for a few minutes and then restart the device
(see Section 1.4 on page 55). If the LED turns red again,
then please contact your vendor.
SYS Green Off The ZyWALL is not ready or has failed.
On The ZyWALL is ready and running.
Flashing The ZyWALL is restarting.
AUX Green Off The AUX port is not connected.
Flashing The AUX port is sending or receiving packets.
On The AUX port is connected.
Ports 1 ~ 7 Green Off There is no traffic on this port.
Flashing The ZyWALL is sending or receiving packets on this port.
Orange Off There is no connection on this port.
On This port has a successful link.
Card1,2 Green Off Reserved for future use. There is no card in the slot.
On There is a card in the slot.
Flashing The card in the slot is sending or receiving traffic.