6
USING ROUTING PROTOCOL
COMMANDS
This chapter describes how to use the following commands:
Routing Table Display Commands
■ display ip routing-table
■ display ip routing-table acl
■ display ip routing-table ip_address
■ display ip routing-table ip_address1 ip_address2
■ display ip routing-table ip-prefix
■ display ip routing-table protocol
■ display ip routing-table radix
■ display ip routing-table statistics
■ display ip routing-table verbose
Static Route Configuration Command
■ delete static-routes all
■ ip route-static
RIP Configuration Commands
■ checkzero
■ default cost
■ display rip
■ filter-policy export
■ filter-policy import
■ host-route
■ import-route
■ network
■ peer
■ preference
■ reset
■ rip
■ rip authentication-mode
■ rip input