Filter
Top Products
236 CHAPTER 11: USING AAA AND RADIUS COMMANDS
802.1x Configuration
Commands
This section describes how to use the 802.1x configuration commands on your
Switch 4500.
display dot1x Syntax
display dot1x [ sessions | statistics [ interface interface-list ]]
View
All views
Parameter
interface: Displays the 802.1x information on the specified interface.
sessions: Displays the session connection information of 802.1x.
statistics: Displays the relevant statistics information of 802.1x.
interface-list: Ethernet interface list including several Ethernet interfaces,
expressed in the format
interface-list = { interface-num [ to
interface-num ] } & < 1-10 >
. interface-num specifies a single Ethernet
interface in the format
interface-num = { interface-type interface-num |
interface-name }
, where interface-type specifies the interface type,
interface-num specifies the interface number and interface-name specifies the
interface name. For the respective meanings and value ranges, refer to
“Parameter” in “Using Port Commands”.
Description
Use the display dot1x command to view the relevant information of 802.1x,
including configuration information, running state (session connection
information) and relevant statistics information.
By default, all the relevant 802.1x information about each interface will be
displayed.
This command can be used to display the following information on the specified
interface: 802.1x configuration, state or statistics. If no port is specified when
executing this command, the system will display all 802.1x related information.
For example, 802.1x configuration of all ports, 802.1x session connection
information, and 802.1x data statistical information. The output information of
this command can help the user to verify the current 802.1x configurations so as
to troubleshoot 802.1x.
Related commands: reset dot1x statistics, dot1x, dot1x retry, dot1x
max-user
, dot1x port-control, dot1x port-method, dot1x timer.
Example
Display the configuration information of 802.1x.
<4500>display dot1x
Equipment 802.1X protocol is enabled
DHCP-launch is disabled
EAP-relay is enabled
Proxy trap checker is disabled
Proxy logoff checker is disabled