Filter
Top Products
284 CHAPTER 11: USING AAA AND RADIUS COMMANDS
View
RADIUS Scheme View
Parameter
retry-times: Specifies the maximal retransmission times after stopping
accounting request,. ranging from 10 to 65535. By default, the value is 500.
Description
Use the retry stop-accounting command to configure the maximal
retransmission times after stopping accounting request. Use the
undo retry
stop-accounting
command to restore the retransmission times to the default
value.
Because the stopping accounting request concerns account balance and will affect
the amount of charge, which is very important for both the user and ISP, NAS shall
make its best effort to send the message to RADIUS accounting server.
Accordingly, if the message from the Switch to RADIUS accounting server has not
been responded, the Switch shall save it in the local buffer and retransmit it until
the server responds or discard the messages after transmitting for specified times.
Related commands: reset stop-accounting-buffer, radius scheme, display
stop-accounting-buffer
.
Example
To indicate that, when stopping accounting request for the server “3Com” in the
RADIUS server group, the Switch will retransmit the packets for up to 1000 times,
enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]radius scheme 3Com
[4500-radius-3Com]retry stop-accounting 1000
secondary accounting Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
RADIUS Scheme View
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
second accounting server is at 0.0.0.0.
port-number: Specifies the UDP port number, ranging from 1 to 65535. By
default, the accounting service is provided via UDP 1813.
Description
Use the secondary accounting command to configure the IP address and port
number for the second RADIUS accounting server. Use the
undo secondary
accounting
command to restore the IP address and port number to default
values.