Filter
Top Products
Disassembly and Unit Replacement 4-21
4.5.9 Removing the Touchpad
The touchpad is connected to the top cover. Follow these steps to remove the touchpad
assembly:
1. Peel off the mylar.
2. Remove the three screws and disconnect the touchpad cable (J2), then remove the touchpad
main sensor and connector unit.
3. Lift up and remove the touchpad.
4. Lift up and remove the touchpad buttons.
Figure 4-26 Removing the Touchpad
Touchpad mylar
Touchpad cable
Touchpad and circuit
Touchpad knob
Screw list:
¶¶
x 3, M2L4