Filter
Top Products
Appendix B: Tool-less rail kit installation
170
4.Making certain the proper mounting holes on rack upright
are selected, repeat the above step at the Slide Rail front
mounting position. Ensure Slide Rail is level.
5.Fully extend the Slide Rail to its fully extended (locked)
position. Press the Slide Extension Release Levers to release
the lock. Move the Slide Rail in and out throughout its entire
range of motion and make certain it does not bind. If binding
is noticed, recheck the mounting positions.
6.Repeat steps 2 through 5 for the right Slide Rail, ensuring
that it is parallel and level with the left Slide Rail.
Installing the Component into the Slide Rails
Note: If optional Cable Management Arm (CMA) is to be installed,
install it now before installing the component. Access to rear of
Slide Rails is required to install the CMA. (See Cable Management
Arm Installation on the other side of this sheet for CMA
installation instructions.)
1.Extend both Slide Rails into the fully extended (locked) position.
2.Align the mounting studs with the Component Mounting
Channels on the Slide Rails.
3.Carefully place the component's mounting studs in the
Component Mounting Channels on the Slide Rails.
Allow the component mounting studs to fully seat in the Component
Mounting Channels. The Component Release Levers (one on each Slide
Rail) pivot out of the way and then back in place when the studs are