Filter
Top Products
55
end of the Drive 5 power cable to the connector on the backplane that
is labeled "OPT CONN."
10.Install the fan module.
11.Install the chassis cover.
12.Install the SCSI hard disk drive into the sixth drive position.
13.Install the front bezel.
Installing a Tape Drive in Altos R710
To install a tape drive into your Altos R710 System, your system must
meet the following requirements:
You must purchase the optional tape drive kit.
You must purchase a 3.5-inch SCSI tape drive.
After purchasing the tape drive kit and the tape drive, use the
instructions below to install them. In addition to these instructions,
refer to the instructions that came with your tape drive for additional
requirements.
1.Observe the safety and ESD precautions at the beginning of this
book.
2.Power down the server and unplug all peripheral devices and the AC
power cable.
3.Remove the chassis cover.
4.Remove the front bezel.