Filter
Top Products
45
Installing or Removing a Floppy, CD-
ROM, or DVD-ROM Drive
Floppy, CD-ROM, and DVD-ROM drives are NOT hot swappable.
Before removing or replacing the drive, you must first take the
server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and
unplug the AC power cord from the system or wall outlet or
disconnect the DC mains.
Install a Slimline Floppy Drive into Altos R710
1 Power down the server system and unplug all peripheral devices
and the AC power cable.
2 Remove the chassis cover.
3 Remove the front bezel.
4 Align the two holes at the left side of the floppy drive with the
two cutouts in the floppy drive carrier. See letter “A” in the figure
below.
5 Lower the right side of the floppy drive into the carrier until it
clicks into place.
6 Open the connector on the rear of the floppy drive by pulling up
on the connector cover. See letter “A” in the figure below.
A
B