Filter
Top Products
173
Installing the CMA on the Slide Rails
1.Pull the Slide Rails out to the fully extended (locked) position.
2.Loosely position the CMA in mounting position, noting the
placement requirements specified above.
Note: The CMA is shipped with the Spacer Block not installed.
Install the Spacer Block on the CMA mounting point chosen to be
the rear (pivoting) end of the installed assembly.
3.Place the Spacer Block in mounting position on the end of the
CMA chosen to be the rear (pivoting) end. Attach the CMA (along
with Spacer Block) to the rear of Slide Rail using the captive
thumbscrew.
4.Attach the Anti-sag Bar to the Anti-sag Bar Sliders on the left
and right Slide Rails.
5.At the front (sliding) end of the CMA, fully extend the CMA,
then attach the CMA to the Slide Rail track using the captive