Filter
Top Products
www.packardbell.com
105
Replacing the dc-in cable
Tools you need to complete this task:
Screws removed during this task:
• 2 black M2.5×8 (LCD panel hinges - bottom)
• 2 black M2.5×8 (LCD panel hinges - top)
• 13 black M2.5×8 (palm rest
- base side)
• 3 black M2.5×8 (palm rest - top side)
To replace the dc-in cable:
1 Complete the steps in “Preparing the notebook” on page 51.
2 If the notebook has a wireless card installed, follow step 1 to step 4 in
“Replacing the wireless card” on page 58.
3 Remove the keyboard by following the instructions in “Replacing the
keyboard” on page 77 .
4 Remove the keyboard cover by following the instructions in “Replacing the
keyboard cover” on page 79.
5 Remove the LCD panel assembly by following the instructions in “Replacing
the LCD panel assembly” on page 83.
6 Remove the palm rest by following the instructions in “Replacing the palm
rest” on page 87.
7 Carefully lift up the dc-in cable from the base panel as shown.
8 Replace the new dc-in cable into the base panel.
Flat-blade driver Scribe or non-marring tool
- OR -
Phillips #0 screwdriver