Filter
Top Products
www.packardbell.com
89
12 Disconnect the touchpad board and touchpad button board cables from
TP335 and FP2 connectors.
13 Carefully pry loose the palm rest from the system and lift the palm rest from
the system.
14 Place the new palm rest assembly on top of the base enclosure and press
it down on all sides until it snaps into place.
15 Reconnect the speaker cable, touchpad board cable, touchpad button board
cable, and DC-in cable to their respective system board connectors.
16 Secure the palm rest assembly with the screws removed in steps 7 and 9.
17 Reinstall the LCD panel assembly by following the instructions in “Replacing
the LCD panel assembly” on page 83.
18 Reinstall the keyboard cover by following the instructions in “Replacing the
keyboard cover” procedure on page 79.
19 Reinstall the keyboard by following the instructions in “Replacing the
keyboard” on page 77.
20 If you have disconnected any wireless antennas, reconnect them now.
21 Replace the bay cover, then tighten the cover screws.
22 Reinstall the battery.