Filter
Top Products
CHAPTER 3: Replacing notebook components
76
5 Remove the VGA board.
6 Install the VGA board, then replace the screws removed in step 4.
7 Remove any thermal grease residue from the cooling assembly using a soft
cloth and isopropyl alcohol.
8 Place new thermal grease on the VGA chip on the VGA board. Use only
enough to cover the VGA die.
9 Place new thermal grease on the processor. Use only enough to cover the
CPU die.
10 Make sure a thermal pad is placed between the cooling assembly and other
components.
11 Replace the cooling assembly by following the instructions in “Replacing the
thermal module” on page 70.
12 Replace the bay cover, then tighten the cover screws.
Note
Circuit boards >10 cm
2
has been highlighted with a yellow rectangle as
above image shows. Please detach the board and follow local regulations
for disposal.