Filter
Top Products
Activation of the Raven CDMA
8 Raven CDMA User Guide for Verizon, version 2.23
Activating the Raven using AT Commands
An alternate method to configure and activate your Raven is by AT commands (full
listing beginning on page 53) sent directly to the modem via a terminal application.
This method is recommended only in situations where the Setup Wizard is not
available and/or the configuration for the
Raven is unusual.
Raven Indicator Lights
When your Raven is connected to power and an antenna, there is a specific pattern
to the lights to indicate its operation mode.
FIGURE 2. Raven indicator lights
Caution: While you can configure your Raven using Wireless
ACE (page
10) or AceNet (page 11), it is not recommended to
activate the Raven using either Wireless ACE or AceNet.
Tx (transmit) and Rx (receive) - Lights will flash as data is transferred to and
from the
Raven on the remote network.
RSSI - Light shows the strength of the signal and may be nearly solid (strong signal) or
flashing (weaker signal). A slow flash indicates a very weak signal.
Reg - Indicates the Raven has acquired an IP from Verizon.
Chan - Indicates the modem has acquired a network channel.
Link - Indicate a successful connection to the cellular network.