Filter
Top Products
Raven CDMA User Guide for Verizon, version 2.23 85
SNMP (Simple Network Management Protocol)
Simple Network Management Protocol (SNMP) can be used to monitor devices
connected to a network for any conditions which warrant administration attention.
By default, SNMP uses port 161, however most Internet providers (including cellu
-
lar) block all ports below 1024 as a security measure.
RKEY=n n= 0 or Radio Transceiver Keying.
0 : Off (Default)
1 : On
Enable/disable MDS Radio transceiver keying. Radio
keying is designed to assert CTS when a packet is
received, delay the time as specified, send the data out
the serial port, wait the same amount time, drop CTS.
This way, the CTS signal can be used to key a transmit
-
ter on and give it time to reach its power level before
data is sent to it. Delay interval is specified in S221.
Cannot be configured in Wireless ACE.
S53=[method][][d.d.d.d][/
ppppp]
method =
P - UDP
T - TCP
N - Telnet
d.d.d.d = IP or
name adresse
ppppp = the port
address
Destination IP address, port, and method. These are used
as defaults for the D (Dial) AT command.
Examples:
ATS53=T192.168.100.23/12345
ATS53=foo.earlink.com
Telnet to the specified IP at port 12345
ATS53=192.168.100.23/12345
Query the specified IP at port 12345
ATS53=/12345
Query port 12345
*DPORT=n n=1-65535 The modem's Device Port. Can also be set with the com-
mand S110.
TABLE 16. Modbus Settings
Command Parameters Details