Filter
Top Products
62 Raven CDMA User Guide for Verizon, version 2.23
Activation
The preferred method of activating (provisioning) the modem is using the Setup
Wizard. However, there are special circumstances when commands may be used
instead.
Qn n=0 or 1 The AT quiet-mode setting. If quiet mode is set, there
will be no responses to AT commands except for data
queried.
0 : Off (Default)
1 : Quiet-mode on
Vn n=0 or 1 Command Response Mode.
0 : Terse (numeric) command responses
1 : Verbose command responses (Default).
Xn n=0 or 1 Extended Call Progress Result mode.
0 : Turn off extended result codes (Default).
1 : Turn on result codes. This adds the text 19200 to the
CONNECT response.
Z none Reset the Raven.
Note: This command does nothing if *DATZ=1.
&F none Restore Factory Setting.
&W none Writes all changed modem settings. If this command is
not issued, any modified values will revert back to their
previous values at modem reset.
*DATZ=n n=0 or 1 Enables or disables reset on ATZ.
0 : Normal Reset (Default)
1 : Disable Reset on ATZ
Caution: You may need go into PassThru mode to use some of
the commeands in this section to activate the Raven.
TABLE 3. Basic Commands (common AT commands)
Command Parameters Details